Please use the form below to provide your feedback. Because your feedback is valuable to us, the information you submit in this form is recorded in our issue tracking system (JIRA), which is publicly available. You can track the status of your feedback using the ticket number displayed in the dialog once you submit the form.

Setting Recovery Type

    +
    Node recover type is set with the POST /controller/setRecoverType HTTP method and URI.

    HTTP method and URI

    Sets the recovery type to be performed for a node. Recovery options are delta node recovery or full recovery. The recovery type for a node is set after the node is failed over and before rebalance. Rebalance is required to apply the recovery.

    POST /controller/setRecoveryType

    The progress of setting recovery type can be tracked just like rebalance. After the data is persisted to disk and replicas are up-to-date, the node is put into the failed over state.

    Syntax

    POST /controller/setRecoveryType
    otpNode=[node@hostname]
    recoveryType=[full|delta]

    Example

    The following Curl request example sets delta node recovery.

    curl -u Administrator:password -d 'otpNode=ns_1@10.5.2.118' -d 'recoveryType=delta' \
http://10.5.2.54:8091/controller/setRecoveryType

    Response codes

    200       // Request succeeded
400       // recoveryType and/or otpNode could not be understood by the server
404       // The cluster is running in a pre-3.0 compatibility mode and thus
             cannot satisfy the request